I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?
I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?
Where could that twist be?
My guess would be from one side of the x-axis to the other, because then on one side the nozzle to probe offset would be less in Z then on the other. But it could also be anywhere else. Can you check if your frame is square?
I am constantly manually tweaking Z offset at the start of prints so here’s hoping the heatsoak solves that.