Heat soak should not change what you have here. During the heat soak, machine expands a little. You will get a more usefull Z / mesh when the machine gets to equilibrium.

If you still have problems after that, it’s probably a X twisted, see the linked document above. Unfortunately I do not have much time to dig into your configs.

I don’t have any experience with beacon. I use Tap or Klicky. With a twisted X, as tap use the nozzle, it should work even with a twisted X

You have a lot of possible options here.

• Your bed is ok, mine is 0.6 variation (sad I know)

1. dish soap with no additives, rinse and dry it correctly before installing it back
2. Verify that it’s doing this in the good order :

• Pre-heat bed
• Home XYZ
• Bed leveling
• Re home Z
• Bed Mesh
• Start print

If everything is ok, as someone else said, it’s maybe a X twist -> https://docs.vorondesign.com/community/troubleshooting/bryansj/twisted_x_extrusion_diagnostics.html